Canon TX-20 Full Auto Tonometer Manuale
46
4BasicOperation
Torestartmeasurement
• Press the measurement button.
• Press the measurement button.
If you are doing a set number of measurements, when the measurement button is pressed the eye
to which the measurement unit is positioned is measured once.
to which the measurement unit is positioned is measured once.
Ifamessageappears
Check “7 Troubleshooting” (see page 77) and perform the remedy indicated in the message.
Check “7 Troubleshooting” (see page 77) and perform the remedy indicated in the message.
2) Three consecutive measurements are performed.
When the position is aligned, three measurements are done consecutively.
3) The measurement unit moves to the other eye.
The set number of measurements is done and the measurement unit moves to the other eye
automatically.
automatically.
Except for the full auto-alignment mode, switching between the left and right eye is done manually.
4) Alignment is done with the left eye; three measurements are done consecutively.
5) The measurement results are printed (see page 36).
L-IE-5191C_TX-20.indb 46
2013/07/18 13:10:29