Canon Océ VarioPrint 6000+ Series Manuale
Replace a die set
Introduction
). The die set determines the punching pattern.
Please contact your puncher supplier for additional or replacement die sets.
This section describes how to remove and install a die set.
NOTE
Only replace a die set when the printer is on hold.
Illustration
[53] Replace a die set
Procedure
1.
Open the front door of the puncher.
2.
Grasp the finger hole of the die set and pull firmly. Slide the die set out of the slot. Make sure that
you support the die set with both hands.
you support the die set with both hands.
3.
If possible, place the removed die set into the storage area inside the puncher cabinet.
CAUTION
The next 2 steps include a possible pinching hazard! Keep your fingers and other body parts
away from the die set slot and the die set pins.
away from the die set slot and the die set pins.
4.
Support the die set with both hands and slightly slide the die set into the slot.
5.
Grasp the finger hole of the die set and push until the die set locks. A firm push can be required.
6.
Close the front door of the puncher.
Replace a die set
Chapter 10 - Optional finishers and other devices
175