Olympus PT-041 Manuale Istruttivo
EN 19
En
Seal the Case.
Check the operation of the loaded camera.
After sealing the Case, check that the camera functions normally.
1
1
Push the POWER button on the Case and confirm that the camera
turns ON/OFF.
turns ON/OFF.
2
Turn the mode dial on the Case and confirm that the camera mode
switches properly.
switches properly.
• Check if the correct mode is being switched from the LCD monitor.
3
Press the shutter lever on the Case and confirm that the camera
shutter releases.
shutter releases.
• Also operate other control buttons on the Case and confirm that the
camera functions properly.
Close the rear lid gently (so that the
O-ring does not slip out of the
groove), hook the buckle on the
edge of the rear lid, and tilt the
buckle lock/unlock lever in the
direction of the arrow to seal the
Case hermetically.
O-ring does not slip out of the
groove), hook the buckle on the
edge of the rear lid, and tilt the
buckle lock/unlock lever in the
direction of the arrow to seal the
Case hermetically.
CAUTION:
• Seal the Case by turning both buckle lock levers down in arrow direction.
When one of the buckles is left open, the Case will not be sealed and water
leakage will occur.
leakage will occur.
• Close the rear lid of the Case so that the LCD hood and the lens cap strap
don’t catch. If they catch, water leaks may result.
PT-041_EN.book Page 19 Friday, August 17, 2007 5:42 PM