Netgear FVS318N – Prosafe Wireless N VPN Firewall Guida All'Installazione Rapida
Initial Access and Basic IPv4 Internet Configuration
3
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
5.
Click Login. The web management interface displays, showing the Router Status screen.
After 5 minutes of inactivity (the default login time-out), you are automatically logged out.
Access Troubleshooting Tips
If you cannot access the wireless VPN firewall’s web management interface from a computer
on your local network, check the following:
on your local network, check the following:
•
Double-check the Ethernet connection between the computer and the wireless VPN
firewall as described in the Installation Guide.
firewall as described in the Installation Guide.
•
Make sure that you are using the SSL https://address login rather than the http://address
login.
login.
•
Make sure that your browser has Java, JavaScript, or ActiveX enabled. If you are using
Internet Explorer, click Refresh to be sure that the Java applet is loaded.
Internet Explorer, click Refresh to be sure that the Java applet is loaded.
•
Try quitting the browser and launching it again.
•
Clear the browser’s cache.
•
Make sure that you are using the correct login information. The factory default login name
is admin, and the password is password. Make sure that Caps Lock is off when entering
this information.
is admin, and the password is password. Make sure that Caps Lock is off when entering
this information.
•
If your computer’s IP address is shown as 169.254.x.x:
Windows and Mac operating systems generate and assign an IP address if the computer
cannot reach a DHCP server. These autogenerated addresses are in the range of
169.254.x.x. If your IP address is in this range, double-check the connection from the
computer to the wireless VPN firewall and reboot your computer.
cannot reach a DHCP server. These autogenerated addresses are in the range of
169.254.x.x. If your IP address is in this range, double-check the connection from the
computer to the wireless VPN firewall and reboot your computer.
If the wireless VPN firewall does not save changes you have made in the web management
interface, check the following:
interface, check the following:
•
When entering configuration settings, be sure to click the Apply button before moving to
another menu or tab, or your changes are lost.
another menu or tab, or your changes are lost.
•
Click the Refresh or Reload button in the web browser. The changes might have
occurred, but the web browser might be caching the old configuration.
occurred, but the web browser might be caching the old configuration.
Note:
For information about the menu layout of the web management
interface, see the “Web Management Interface Menu Layout”
section in Chapter 1, “Introduction,” of the Reference Manual.
section in Chapter 1, “Introduction,” of the Reference Manual.