KitchenAid 30-Inch 4 Burner Gas Rangetop, Commercial-Style Guida All'Installazione

Electrical Requirements

IMPORTANT: The cooktop must be electrically grounded in 

accordance with local codes and ordinances, or in the absence 

of local codes, with the National Electrical Code, ANSI/NFPA 70 

or Canadian Electrical Code, CSA C22.1.
This cooktop is equipped with an electronic ignition system 

that will not operate if plugged into an outlet that is not 

properly polarized.
If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrical installer determine 

that the ground path is adequate.
A copy of the above code standards can be obtained from: 

National Fire Protection Association 

1 Batterymarch Park 

Quincy, MA 02169-7471

CSA International 

8501 East Pleasant Valley Road 

Cleveland, Ohio 44131-5575

 

■

A 120-volt, 60 Hz, AC-only, 15-amp, fused electrical circuit 

is required. A time-delay fuse or circuit breaker is also 

recommended. It is recommended that a separate circuit 

serving only this cooktop be provided.

 

■

Electronic ignition systems operate within wide voltage limits, 

but proper grounding and polarity are necessary. Check that 

the outlet provides 120-volt power and is correctly grounded.

 

■

The wiring diagrams are provided with this cooktop. The 

wiring diagrams are located inside the control console and 

in the “Wiring Diagrams” section.

Gas Supply Requirements

Observe all governing codes and ordinances.
IMPORTANT: This installation must conform with all local codes 

and ordinances. In the absence of local codes, installation must 

conform with American National Standard, National Fuel Gas 

Code ANSI Z223.1 - latest edition or CAN/CGA B149 - latest 

edition.
IMPORTANT: Leak testing of the cooktop must be conducted 

according to the manufacturer’s instructions.

 

■

This cooktop is factory-set for use with Natural gas. To 

convert to LP gas, see the Gas Conversion instructions 

provided in the package containing literature. The model/

serial/rating plate located on the left underside of the 

cooktop burner base has information on the types of gas 

that can be used. If the types of gas listed do not include 

the type of gas available, check with the local gas supplier.

LP Gas conversion:
Conversion must be done by a qualified service technician. 
No attempt shall be made to convert the cooktop from the gas 

specified on the model/serial/rating plate for use with a different 

gas without consulting the serving gas supplier. To convert to LP 

gas, use the LP gas conversion kit provided with the cooktop 

and see the “Gas Conversions” section.

 

■

Provide a gas supply line of 

3

/

4

" (1.9 cm) rigid pipe to the 

cooktop location. A smaller size pipe on longer runs may 

result in insufficient gas supply. With LP gas, piping or tubing 

size can be 

1

/

2

" (1.3 cm) minimum. Usually, LP gas suppliers 

determine the size and materials used in the system.

NOTE: Pipe-joint compounds that resist the action of LP gas 

must be used. Do not use TEFLON

®†

 tape.

†

®

TEFLON is a registered trademark of Chemours.