Xerox 4213 MICR MRP Guida Utente
POSTSCRIPT EMULATION
3. Pull the system controller board out approximately 102 mm
(4 inches) along the receiving rails.
4. Depress the clip to disconnect the cable connector from the
system controller board at J7.
5. Disconnect the cable connector from the system controller
board at J2.
Note: Connection is snug. A gentle back-and-forth and
side-to-side rocking motion will help to loosen it.
side-to-side rocking motion will help to loosen it.
6. Lift slightly and pull to remove the system controller board
from printer, and place it on a firm, flat surface.
Mounting pegs installation
7. Remove the PDL board and the mounting pegs from their
packaging. (Refer to figure A4-4.)
Caution: Care should be taken when handling the PDL
board, as there are sharp contacts on the top side of the
board.
board, as there are sharp contacts on the top side of the
board.
8. Locate the mounting peg install holes on the system
controller board near J6.
9. Put the mounting pegs into the holes on the system
controller board near J6. Push down on the pegs until they
are fully seated.
are fully seated.
10. Locate the socket/connector (J16) on the system controller
board.
XEROX 4213 LASER PRINTER USER GUIDE
A4-5