Xerox 4215 MICR MRP Guida Utente

NOTICES

Always connect equipment to a properly grounded power source
receptacle.  If in doubt, have the receptacle checked by a
qualified electrician.

Always place equipment on a floor with adequate strength for
the weight of the machine.

Always have your service representative move or relocate the
equipment.

Always use materials and supplies specifically designed for your
Xerox equipment.

WARNING:  Use of unsuitable materials may result in poor
performance and can possibly create a hazardous condition.

Always use a Xerox specified cordset with the Equipment Leakage
Current Interrupter/Residual Current Device (ELCI/RCD).

Never use an extension cord with the ELCI/RCD.

Never use the ELCI/RCD where water may enter the casing.

Never attempt any maintenance function that is not specifically
described in this document.

Never remove any covers or guards that are fastened with screws
unless otherwise instructed.  There are no operator-serviceable
areas within these covers.

Never override or “cheat” electrical or mechanical devices.

Never operate the equipment if you notice unusual noises or
odors.  Disconnect the power cord from the power source
receptacle and call service to correct the problem.

U.S. only:  If you need any additional safety information
concerning the equipment or Xerox supplied materials, call the
following toll-free number:  1-800-828-6571.

Listed by Underwriters Laboratories, UL1950 (UL).  Meets CSA
standards, C22.2 NO 950 (CSA).

Meets the British Standards Institution, IEC950 (BSI).

Your Xerox printer is equipped with an Equipment Leakage
Current Interrupter/Residual Current Device (ELCI/RCD).  This
safety device protects you if an electric outlet supplying power
to the printer is improperly wired.

XEROX MRP FAMILY APPLETALK INTERFACE OPERATOR GUIDE

vii