Xerox DocuTech 2000 Series 90 Guida Utente

Installation

Using the Xerox Client Software for Solaris

1-4

Installation

NOTE: If you are installing the Xerox command line client
software on a Unix workstation that already contains an earlier
version of the software, first perform the procedure, “Removing
the Xerox client software from Unix based workstations” in this
chapter.

Prior to DocuSP 1.1, the Xerox command line client software
was installed in the /usr/xerox/nps directory.

Refer to the on-line man pages for additional information about
the Unix commands used in the following procedure.

The following examples use the name proofqueue as the name
of the print queue and the name printsrv as the hostname of the
DocuSP controller. These should be replaced with the hostname
of the DocuSP controller and the name of a print queue that
exists in your installation.

The software is installed using ftp over the TCP/IP link as
follows:

1. Log in as root at the client workstation.

2. Verify that there is sufficient disk space as listed in the

requirements at the beginning of this section.

3. If the system is not in an NIS environment, you must add an

entry for the DocuSP controller to the hosts file using the
admintool.

4. Verify the connection to the DocuSP controller by entering

the following command:

ping printsrv

If your workstation can see the DocuSP controller you should
see:

printsrv is alive

5. Enter the following command to change to a temporary

working directory to hold the installation script:

cd /tmp

6. Connect to the DocuSP controller using ftp. Login as ftp and

use ftp as the password. For example:

ftp printsrv
Connected to printsrv
220 printsrv FTP server (Unix(r) System V
Release 4.0) ready.
Name (printsrv:cdoc):