Xerox DocuTech 180 HighLight Color System Guida Utente

NOTE:   Production publisher configuration only

Use this procedure to replace the binder tape in the system.
To ensure proper binding and to reduce binder tape jams, do not 
leave binder tape in the system when the binder is not in use.
If necessary, refer to the label on the binder for instructions on how 
to replace the binder tape.
The following steps must be performed to replace the binder tape 
wheel.

WARNING:  All areas of the binder drawer, including the binder 
tape, are hot, approximately 425°F (218°C), and may cause 
serious burns. If the binder has been in a "Ready" condition, allow 
the binder drawer to cool at least one hour before continuing the 
procedure.

1. Open the finisher doors.
2. Grasp the green handle on the binder drawer and pull the 

drawer out until it stops.

3. Remove the tape from the drive roll.

a. Lift the pressure roll release handle and remove the tape 

from the drive roll.