Xerox DocuTech 180 HighLight Color System Guida Utente
4-26
DocuTech 128/155/180 HighLight Color Operator Guide
Problem Solving
2. Open the top cover.
WARNING: The binder tape adhesive is hot, approximately 425°F
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
3. Follow the instructions on the screen to determine the area (17
or 18) that should be cleared.
4. If area 17 is displayed and the binder tape is present, stop and
follow the WARNING. Remove the binder tape and paper.
Proceed to step 6.
Proceed to step 6.
5. If area 17 is displayed and the binder tape is not present,
follow the instructions on the area 17 label and remove all
paper.
paper.
6. Ensure that area 17 is clear of all binder tape adhesive. If the
area is not clear, clean the binder using the procedure,
"Cleaning the binder," in this guide.
"Cleaning the binder," in this guide.
WARNING: The binder tape adhesive is hot, approximately 425°F
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
(218°C). Allow the binder to cool for 5 minutes with the finisher
doors and top cover open before touching the binder tape.
7. If area 18 is not displayed, proceed to step 10.
8. If area 18 is displayed and the entire binder tape length is not
8. If area 18 is displayed and the entire binder tape length is not
aligned with the tape feeder assembly, stop and follow the
WARNING. Proceed to step 10.
WARNING. Proceed to step 10.
9. If area 18 is displayed and the entire binder tape length is
aligned with the tape feeder assembly, proceed to step 10.
10. Remove the binder tape.
11. Ensure that area 18 is clear of all binder tape adhesive. If it is
11. Ensure that area 18 is clear of all binder tape adhesive. If it is
not, clean the binder using the procedure, "Cleaning the
binder," in the "Routine maintenance" chapter.
binder," in the "Routine maintenance" chapter.
12. Close the finisher doors.
13. Close the top cover.
13. Close the top cover.
Stitcher spool A fault
NOTE: Production publisher configuration only
Repeated jams in area 17 may be caused by the following
problems:
•
problems:
•
Stitcher wire not feeding properly
•
A kink in the stitcher wire
1. Open the finisher doors.
2. Lift the stitcher panel, which is located directly above the
2. Lift the stitcher panel, which is located directly above the
stitcher spools.