Xerox DocuTech 180 HighLight Color System Guida Utente
4-30
DocuTech 128/155/180 HighLight Color Operator Guide
Problem Solving
Figure 4-27 Removing the wire fragments
10. Push the green stitcher head release handle down and back.
11. Pull the plug from the measuring bracket.
12. Insert the plug into the stitcher head until the plug snaps into
11. Pull the plug from the measuring bracket.
12. Insert the plug into the stitcher head until the plug snaps into
place.
NOTE: Ensure that the wire cutters are not touching the stitcher
spools. This can prevent the stitcher wire from feeding properly.
spools. This can prevent the stitcher wire from feeding properly.
13. Place the wire cutters in the storage bracket.
NOTE: Ensure that the stitcher panel has been lowered. The
stacker will not deliver printed sets if the stitcher panel is left in the
up position
stacker will not deliver printed sets if the stitcher panel is left in the
up position
14. Lower the stitcher panel.
15. Close the finisher doors. The printer icon indicates "Ready."
15. Close the finisher doors. The printer icon indicates "Ready."
Checking paper curl
You can adjust the decurler lever to correct most paper curl
problems. Refer to the paper curl chart, later in this chapter, to
determine the amount of curl in the paper stock.
Perform the following to measure paper curl:
1. Print five one sided (simplex) 8.5 by 11 inch or A4 sheets.
problems. Refer to the paper curl chart, later in this chapter, to
determine the amount of curl in the paper stock.
Perform the following to measure paper curl:
1. Print five one sided (simplex) 8.5 by 11 inch or A4 sheets.