Xerox DocuTech 180 HighLight Color System Guida Utente
DocuTech 128/155/180 HighLight Color Operator Guide
2- 15
System components
Interposer
NOTE: Production publisher configuration only.
The 2-Tray or 3-Tray Interposer module is located between the
print engine and the Finisher. The Interposer inserts blank or
preprinted sheets as required. Sheets fed from Tray 4 are not
imaged and feed directly into the finisher. Sheets from Tray 5 or
Tray 6 (Three-tray Interposer) can be set either to feed through
the Interposer via the print engine (passing through the Fuser) or
to deliver pre-printed stocks into the Finisher (post-Fuser).
Both models of Interposer have the ability to process ordered sets
fed from Tray 4. This makes it unnecessary to have additional
trays for each page type in a set. However, for jobs that include
pre-printed sheets that are not pre-collated or several jobs that
use ordered sets, Tray 5 and Tray 6 (3-Tray Interposer) can also
be set to feed directly into the Finisher (post-Fuser).
print engine and the Finisher. The Interposer inserts blank or
preprinted sheets as required. Sheets fed from Tray 4 are not
imaged and feed directly into the finisher. Sheets from Tray 5 or
Tray 6 (Three-tray Interposer) can be set either to feed through
the Interposer via the print engine (passing through the Fuser) or
to deliver pre-printed stocks into the Finisher (post-Fuser).
Both models of Interposer have the ability to process ordered sets
fed from Tray 4. This makes it unnecessary to have additional
trays for each page type in a set. However, for jobs that include
pre-printed sheets that are not pre-collated or several jobs that
use ordered sets, Tray 5 and Tray 6 (3-Tray Interposer) can also
be set to feed directly into the Finisher (post-Fuser).
NOTE: Ordered sets can also be fed for imagining from Trays 1,
2, and 3.
2, and 3.
Two-tray Interposer
(production
publisher only)
The 2-Tray Interposer allows applications to utilize up to five trays
to feed different paper stocks. Both trays may be used to feed pre-
printed stocks (bypassing the Fuser). If just Tray 4 is used for
post-Fuser feeding, four pick points are available for imaging
(passing through the fuser).
The following lists the 2-Tray interposer components
1. Paper transport (lower)
2. Paper transport (upper)
3. Inserter tray
4. Feeder/inserter tray
to feed different paper stocks. Both trays may be used to feed pre-
printed stocks (bypassing the Fuser). If just Tray 4 is used for
post-Fuser feeding, four pick points are available for imaging
(passing through the fuser).
The following lists the 2-Tray interposer components
1. Paper transport (lower)
2. Paper transport (upper)
3. Inserter tray
4. Feeder/inserter tray
Figure 2-9. 2-Tray Interposer (production publisher only)