Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
2. While turning the rollers, gently clean them with a soft cloth moistened with water.
Caution
Use a cloth that has been thoroughly wrung to prevent drops of water falling into
the machine. Drops of water on internal components may cause a malfunction.
the machine. Drops of water on internal components may cause a malfunction.
If dirt is difficult to remove, try gently wiping with a soft cloth moistened with a small
amount of neutral detergent.
amount of neutral detergent.
3. Close the top cover of the document feeder until you hear it click into place.
4. Close the left cover of the document feeder until you hear it click into place.
4. Close the left cover of the document feeder until you hear it click into place.
Cleaning the Drum Drawer Area
When you are replacing a drum cartridge, and before inserting the new cartridge, perform
these steps to clean under the drum cartridge area:
these steps to clean under the drum cartridge area:
1.
With the Drum Cartridge Drawer open, look for dry ink/toner waste on the bottom
of the catch pan under the drum cartridges.
of the catch pan under the drum cartridges.
2.
Use a clean cloth to wipe down the catch pan.
3.
Continue following the instructions on how to insert the new cartridge.
Cleaning the ROS Windows
Unfused dry ink/toner collects on the 4 color ROS window areas located just above the
Drum Cartridge Drawer within the press. Contaminated ROS windows can cause a white
streak defect on your printed output.
Drum Cartridge Drawer within the press. Contaminated ROS windows can cause a white
streak defect on your printed output.
Perform this procedure to clean the ROS window of the affected color whenever:
• You replace the drum cartridge
• A white streak (no image captured) shows in the same position on every print
• A white streak (no image captured) shows in the same position on every print
Note
Use only the wand and cloth pad provided when performing this cleaning procedure.
Do not use any other cleaning device, liquid solutions, or cloths.
Do not use any other cleaning device, liquid solutions, or cloths.
1. Open the Left Front Door of the press.
2. Locate the Cleaning Wand tool stored on the side panel of the open front door and
2. Locate the Cleaning Wand tool stored on the side panel of the open front door and
remove.
Make sure the pad at the tip of the wand is clean. Replace the pad after 4 uses. Several
pads are provided in the Nationalization Kit. To acquire additional pads, contact your
Service representative.
Make sure the pad at the tip of the wand is clean. Replace the pad after 4 uses. Several
pads are provided in the Nationalization Kit. To acquire additional pads, contact your
Service representative.
Xerox
®
Versant
®
80 Press
13-4
User Guide
Press Maintenance