Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Guida Utente
• Once the Punch Container is full, the User Display Panel on the AdvancedPunch Pro
displays a Chip Tray Full message.
• A message also appears on the press User Interface / Control Panel.
1. Grasp the handle of the Punch Container and pull out the container.
2. Empty the paper remnant contents into the appropriate trash bin.
3. Reinstall the Punch Container into the AdvancedPunch Pro.
2. Empty the paper remnant contents into the appropriate trash bin.
3. Reinstall the Punch Container into the AdvancedPunch Pro.
Die Set Maintenance
Every die set is thoroughly oiled at the factory prior to shipping. During normal use this
oil is depleted and should be replaced. This periodical maintenance ensures proper
functionality and prevents premature failure of the die set.
oil is depleted and should be replaced. This periodical maintenance ensures proper
functionality and prevents premature failure of the die set.
Tip
As part of regular maintenance, each die set should be oiled after approximately 100,000
punch cycles. The use of brand 3-IN-ONE
punch cycles. The use of brand 3-IN-ONE
®
oil is recommended because this oil is readily
available; other light machine oils may also be used.
The procedure for lubricating the die set pins is slightley different depending on whether
or not the die set has a felt pad.
or not the die set has a felt pad.
Important
After oil has been applied, reinstall the die set into the AdvancedPunch Pro and run a
small set of test prints. It is normal for oil to be present on the first set of sheets punched
after oiling the die set. After approximately 25 to 50 sheets, the punched output will be
clean and free of oil, and the AdvancedPunch Pro now may be used for punch jobs.
small set of test prints. It is normal for oil to be present on the first set of sheets punched
after oiling the die set. After approximately 25 to 50 sheets, the punched output will be
clean and free of oil, and the AdvancedPunch Pro now may be used for punch jobs.
Lubricating Die Set Pins (without a Felt Pad)
1. Press the die set so that the pins protrude from the bottom plate.
2. Apply a drop of high quality machine oil to the end of each pin.
3. Wipe clean, leaving a light coat of oil on them.
2. Apply a drop of high quality machine oil to the end of each pin.
3. Wipe clean, leaving a light coat of oil on them.
Oil from the die set may blemish the first few punched sheets after oil has been
applied.
applied.
4. Run punched test prints until the punched output is clean and free of oil.
Lubricating Die Set Pins (with a Felt Pad)
1. Lubricate with a high quality machine oil.
Xerox
®
Versant
®
80 Press
22-22
User Guide
GBC AdvancedPunch Pro