Craftsman 11543X Manuale Utente

5 — English

 Do not use this product if it is not 

completely assembled or if any parts appear to be 
missing or damaged. Use of a product that is not 
properly and completely assembled could result in 
serious personal injury.



  If any parts are damaged or missing, please call 

1-800-932-3188 for assistance.

Do not attempt to modify this product 

or create accessories not recommended for use with 
this product. Any such alteration or modification is 
misuse and could result in a hazardous condition 
leading to possible serious personal injury.

This battery charger meets the Energy Star energy- 
efficiency guidelines set by the U.S. Environmental 
Protection Agency and the U.S. Department of Energy. 
Battery chargers meeting this standard use an average of 
35% less energy than conventional battery chargers.

See Figure 1, page i.
The charger has a key hole hanging feature for conve-
nient, space saving storage. Screws should be installed 
so that the center distance is 4-1/2 in.

Do not allow familiarity with products 

to make you careless. Remember that a careless 
fraction of a second is sufficient to inflict serious 
injury.

Always wear eye protection with side 

shields marked to comply with ANSI Z87.1. Failure to 
do so could result in objects being thrown into your 
eyes resulting in possible serious injury.

You may use this product for the following purpose:
 

Charging compatible Craftsman 19.2 volt battery 
packs. 

f at any point during the charging 

process none of the LEDs are lit, remove the 
battery pack from the charger to avoid damaging 
the product. DO NOT insert another battery. Return 
the charger and battery to your nearest authorized 
service center for service or replacement.

NOTICE: 

Charge in a well ventilated area. Do not 

block charger vents. Keep them clear to allow proper 
ventilation.

CHARGING 

See Figure 2, page i.
Battery packs are shipped in a low charge condition to 
prevent possible problems. Therefore, you should charge 
them before first use. If the charger does not charge your 

battery pack under normal circumstances, return both the 
battery pack and charger to your nearest repair center for 
electrical check.
Charge time is approximately 30 minutes, and is 
dependent upon the type of battery pack.


  Make sure the power supply is normal household 

voltage, 



  Connect the charger to a power supply.



  Attach the battery pack to the charger by aligning the 

raised ribs on the battery pack with the grooves in the 
charger, then slide the battery pack onto the charger.



  Press down on the battery pack to be sure contacts on 

the battery pack engage properly with contacts in the 
charger. 



  Do not place the charger in an area of extreme heat or 

cold. It will work best at normal room temperature. 



  The battery pack may become slightly warm to the 

touch while charging. This is normal and does not 
indicate a problem.



  After charging is complete, the green LEDs will remain 

on while the charger is in Maintenance Mode.



  After completing Maintenance Mode, the green LEDs 

will begin fading on/off continuously. This indicates the 
battery is fully charged and the charger is in Energy 
Save Mode.



  Charger will periodically wake from Energy Save Mode to 

ensure the battery pack remains in a fully charged state.



  To remove the battery pack from the charger, depress 

latches and pull up on the battery pack.