Honeywell B Guida All'Installazione

69-0274-6

4 

1. If using the cover ring: Position the cover ring against the wall so 

that the arrow in the middle of the cover ring is pointing up.

2. Position the wallplate or subbase.

• If using cover ring: Place the wallplate/subbase over the cover 

ring. Rotate the wallplate/subbase until the wiring openings are 

aligned and the two screw holes on the left and right side of the 

wallplate/subbase align with the screw holes on the cover ring. 

You will be inserting screws through these holes into the wall.

• If attaching wallplate directly to the wall: Position so that the 

UP indicator on the wallplate is on top.

• If attaching subbase directly to the wall: Position so that the 

fan and heating/cooling switches are on the top.

3. Use a pencil to mark the center of the screw holes on the left and 

right sides of the wallplate or subbase.

4. Remove the wallplate/subbase and cover ring, and drill two 1/16-in. 

holes at the locations you marked.

5. Reposition the cover ring (if used) and wallplate/subbase over the 

holes, pull the wires through the wiring opening, and loosely insert 

the two 1-in. screws into the drilled holes.

Refer to Fig. 5 as you work.

M20187

OUTLET BOX

SUBBASE

COVER RING

1

THERMOSTAT 
WIRING HOLE

THE TWO INNER HOLES ARE USED WITH WALLPLATE.

2

IF OUTLET BOX IS HORIZONTAL, MOUNT COVER RING IN 
POSITION SHOWN, BUT FASTEN WITH SCREWS THROUGH "A".

2

1

A

1/2 IN. BINDING
HEAD SCREW (2)

1/4 IN. 
ROUND
HEAD
SCREW (2)