Zanussi ZQA14033DA Manuale Utente

Food products prevent that water

flows into the water collector.

Make sure that food products do

not touch the rear plate.

Water flows on the floor.

The melting water outlet is not

connected to the evaporative tray

above the compressor.

Attach the melting water outlet to

the evaporative tray.

The temperature in the appliance

is too low/too high.

The temperature regulator is not

set correctly.

Set a higher/lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The food products' temperature

is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Many food products are stored at

the same time.

Store less food products at the

same time.

The door has been opened often. Open the door only if necessary.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of

the same power and specifically designed

for household appliances (the maximum

power is shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Refer to Safety chapters.

Refer to the assembly instructions

for the installation.

To ensure best performance, install the

appliance well away from sources of heat such