Hotpoint-Ariston BWMD 742 (EU) Manuale Utente

Pagina di 56
GB
3
Connecting the drain hose
 
Connect the drain hose, 
without bending it, to a drai-
nage duct or a wall drain 
located at a height between 
65 and 100 cm from the 
floor; 
alternatively, rest it on 
the side of a washbasin 
or bathtub, fastening the 
duct supplied to the tap 
(see figure). The free end 
of the hose should not be 
underwater.
!
 We advise against the use of hose extensions; if it is 
absolutely necessary, the extension must have the same 
diameter as the original hose and must not exceed 150 cm 
in length.
Electrical connections
Before plugging the appliance into the electricity socket, 
make sure that: 
• the socket is earthed and complies with all applicable 
laws;
• the socket is able to withstand the maximum power load 
of the appliance as indicated in the Technical data table 
(see opposite);
• the power supply voltage falls within the values indicated 
in the Technical data table (see opposite);
• the socket is compatible with the plug of the washing 
machine. If this is not the case, replace the socket or the 
plug.
!
 The washing machine must not be installed outdoors, 
even in covered areas. It is extremely dangerous to leave 
the appliance exposed to rain, storms and other weather 
conditions.
!
 When the washing machine has been installed, the elec-
tricity socket must be within easy reach.
!
 Do not use extension cords or multiple sockets.
!
 The cable should not be bent or compressed.
!
 The power supply cable must only be replaced by autho-
rised technicians.
Warning! The company shall not be held responsible in the 
event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and before you use 
it for the first time, run a wash cycle with detergent and no 
laundry, using the wash cycle 
 
(60°C).
65 - 100 cm
Technical data
Model
BWMD 742
Dimensions
width 59.5 cm
height 81.5 cm
depth 54.5 cm
Capacity
from 1 to 7 kg 
Electrical 
connections
please refer to the technical data plate 
fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 52 litres
Spin speed
up to 1400 rotations per minute
Test wash cycles 
in accordance 
with directives 
1061/2010 and 
1015/2010  
programme 
 (60°)
 (1st press of the button)
Standard Cotton 60°C
.
programme 
 (40°)
 (2nd press of the button)
Standard Cotton 40°C
.
This appliance conforms to the following 
EC Directives:
- 2004/108/EC (Electromagnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC