Beko GNE 134620 X Manuale Utente

Pagina di 111
EN
15
Installing Water Filter 
(in some models)
Two different water sources may 
be connected to the refrigerator 
for water supply: the mains cold 
water supply and water in a jug.
Installation Requirements
A pump should be used for jug water 
usage.
Check that the parts stated below are 
supplied with your appliance.
1.  Union for connection of the water 
pipe to the rear of the appliance. 
(If it does not fit, provide it from the 
nearest authorized service.)
2.  2 pieces of pipe clips (In case 
required to secure the water pipe)
Note: Since the following parts are 
not required in use with a jug, they 
may not be found in the product you 
purchased.
3.  5-meter long water pipe (1/4 inch in 
diameter)
4.  Cold mains water valve with mesh 
filter (Tap Adapter)
5.  Water Filter or externally connectable 
filter to be fitted to the bracket inside 
the fridge compartment.
Place where the external filter is going 
to be fitted should be determined 
first. (Applies to the filter being 
used outside the refrigerator.) Then, 
determine the distance between the 
filter and the refrigerator and required 
hose lengths from the filter to the 
refrigerator water inlet.
Water filter must be hold upright as 
shown in the figure. It is important to 
properly attach the filter to water inlet 
and water outlet points.
After attaching the filter, do not use first 
3-4 glasses of water.
Connection of the Water 
Pipe to the Refrigerator
1. After installing the union onto the 
water pipe, insert the water pipe to 
the refrigerator inlet valve by pressing 
downwards firmly.
2. Fix union as seen in the opposite 
figure, by squeezing by hand on the 
refrigerator inlet valve.
3
1
4
2
*5
c
a
a
b
1
2