Kärcher MV(WD) 5 Premium 1.348-230.0 Manuale Utente



Adapt the adapter to the connection diameter of the 
electric tool using a knife if necessary.

Illustration 


A) Plug the enclosed adapter onto the handle of the 
suction hose and connect the electric tool with the 
connection.
or



B) Use the flexible tool hose to gain more flexibility 
in your work. Connect this hose to the suction hose 
and to the adapter and then to the connection of the 
electric tool.

Illustration 


For appliances with built-in socket: Connect the 
mains plug of the electric power tool to the vacuum 
cleaner.

Illustration 
-Switch the appliance on (move the rotary switch to the 

left to position 

 MAX) and start working.

Note: As soon as the electric tool is switched on, the 
suction turbine starts with a 0.5 second delay. If the 
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up 
the remaining dirt in the suction hose.

The filter cleaning system is intended for vacuuming up 
large volumes of fine dust without an inserted filter bag.
Note: Thanks to the filter cleaning system the soiled flat 
pleated filter can be cleaned at the push of the button 
and the suction performance can be increased again. 

Illustration 


Place the handle of the suction hose in the acces-
sory compartment on the appliance head. Push the 
filter cleaning button 3 x while the appliance is 
switched on, wait 4 seconds between the individual 
operations.

Note: After operating the filter cleaning button several 
times, check the container for its filling volume. Other-
wise, the dirt might escape when the container is 
opened.

Cleaning hard to reach locations or, where vacuuming 
is not possible, like leaves from a gravel bed.

Illustration 


Connect the suction hose to the blower connection, 
this will activate the blower function.

Illustration 


Turn off the appliance. 

Illustration 


Hook the floor nozzle into the parking position.



Turn off the appliance and disconnect the mains 
plug.

Illustration 


Remove the appliance head and empty the reser-
voir filled with wet or dry dirt.
For appliances with drain screw: Empty the dry 
dirt over the container. Use the drain screw to emp-
ty liquids.

Illustration 


Stow away the mains cable and accessory at the 
machine. Store the appliance in a dry room.



Clean the appliance and accessory parts made of 
plastic with a commercial plastic cleaner.



If required, rinse the container and accessories 
with water properly and dry them before reuse. 

Recommendation: Clean the filter box after every 
use.
Illustration 


Unlock, fold out and remove the filter cartridge, 
empty dirt from the filter cartridge over a waste bin.



In order to clean the inserted flat fold filter, knock 
the filter box against the edge of the waste bin. It is 
not necessary to remove the flat fold filter from the 
filter box.

Illustration 


Unlock, fold out and remove the filter cartridge.

Illustration 


Remove the flat fold filter from the filter box and tab 
it out.



When necessary, clean under running water only, 
do not wipe or brush down. 
Allow to dry completely prior to use.



Finally, reinstall the dry flat fold filter into the appli-
ance. Insert the filter cartridge into the appliance.

If the suction power becomes less, check the following 
points:


Accessories, suction hose or suction pipes are 
clogged, please remove the obstruction using a 
stick.

Illustration 


Filter bag is full: Insert new filter bag.

Illustration 


Flat fold filter contaminated: Remove the filter box 
and clean filter (see Chapter "Cleaning the flat fold 
filter").



Replace damaged flat fold filter.

H

2

H

2