AL-KO SnowLine 760 TE 112 930 Manuale Utente

Original operating instructions

28

AL-KO snow blowers

Assembly

Caution!
Do not operate the machine until it has 

been fully assembled.

Required tools

 

„ 2 Open-end or ring spanners, size 10

 

„ Open-end or ring spanner, size 13

 

„ +H[NH\PP

 

„ &RPELQDWLRQRUQHHGOHQRVHSOLHUV

 

„ Screwdriver

 

„ Spray oil

 

„ 7\UHSXPSZLWKSUHVVXUHJDXJHDXWRW\UHYDOYH

Assembly sequence

1.  Secure the guide handles of the control panel 

using 3 screws (  1-1).

2.  (  1-2) Leave this hole free for guiding the 

hand crank.

Wheel drive and auger drive.

1.  Turn the adjuster on the control cable in the 

direction of the arrow (  2-2) until the con-

trol cable no longer sags (is slightly tensi-

oned). Hold the cable while tightening so that 

it does not twist.

2.  Tighten the lock nut(  2-1) firmly.
3.  700E 3 control cables, 760TE 5 control 

cables.

 

» The control cables are installed.

1.  Screw together the rods to the control panel 

at the top (  3-1).

2.  Attach the rods to the housing at the bottom.

1.  Place the spring washers (  4-1) on the th-

reads.

2.  Screw on the snow discharge height lever (  

4-2

) and tighten 

3.  Screw on the speed selector lever (  4-3) 

and tighten.

1.  Connect the clip connector from the heating 

and headlight (  5-1).

1.  Lightly lubricate the surface of the snow di-

scharge chute that slides against the snow 
blower with spray oil (  6).

2.  Mount the snow discharge chute (  6).
3.  Insert mounting screws into the lower, larger 

guide plate and attach the smaller guide pla-
te (  7-1).

4.  Insert the guide plates into the snow dischar-

ge chute from below and tighten with the 
self-locking nuts (  7 -2).

5.  Repeat the procedure for the other two gui-

des.

 

» The snow discharge chute is attached.

1.  Attach the control cable in the guide (  8-1, 

8-2

).

2.  Tighten the lock nut (  8-2).

1.  Insert the guide for the hand crank into the 

guide handle and tighten. Do not tighten it yet  
(  9-1).