Cisco Cisco Network-Based Intrusion Detection System Guida Alla Risoluzione Dei Problemi
How to Verify IPS Traffic Inspection and Signature
Alerts
Alerts
Document ID: 116006
Contributed by David Houck and Dustin Ralich, Cisco TAC Engineers.
Mar 18, 2013
Mar 18, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Internal, External and Management Communications
Verify Inspection of Traffic
Verify Signature Fires
Related Information
Prerequisites
Requirements
Components Used
Conventions
Internal, External and Management Communications
Verify Inspection of Traffic
Verify Signature Fires
Related Information
Introduction
This document provides the steps to use in order to verify the operation of an Intrusion Prevention System
(IPS) sensor and signature test options in a production environment.
(IPS) sensor and signature test options in a production environment.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software versions:
Intrusion Prevention System Release 6.2(x)E4
•
Intrusion Prevention System Release 7.0(x)E4
•
Intrusion Prevention System Release 7.1(x)E4
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Internal, External and Management Communications
Use these steps in order to verify IPS management access and readiness:
Access the console in the IPS. If this is a module issue, then enter:
•