Cisco Cisco Packet Data Gateway (PDG) Guida All'Installazione

Adding Application and Line Cards to an Existing Installation

▀ Adding Half-Height Line Cards

▄ ASR 5000 Installation Guide

200

Adding Half-Height Line Cards

This section provides instructions for adding half-height line cards to the chassis.

Caution:

During installation, maintenance, and/or removal, wear a grounding wrist strap to avoid ESD damage

to the components. Failure to do so could result in damage to sensitive electronic components and potentially void your
warranty.

Step 1

Determine the type of line card you are installing. Each line card is identified by the label near the bottom of its front
panel.

Step 2

Determine which chassis slot to install the card in based on the information in

Step 3

Remove the blanking panel covering the slot:

Step a

Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the blanking panel.

Step b

Hold the screws on the blanking panel, and pull the blanking panel away from the chassis to expose

the chassis slot.

Caution:

Do not leave chassis slots uncovered for extended periods of time. This reduces airflow through the

chassis, which could cause it to overheat. Install a card or a blanking panel s in every chassis slot.

Step 4

Slide the interlock switch on the card fully downward. Flip the ejector levers outward and away from the card’s front
panel.