Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guida Alla Risoluzione Dei Problemi
A Guideline to Provision Timing on ONS 15454
Document ID: 64897
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure Timing at the Node Level
General Timing
BITS Facilities
Reference Lists
Configure Timing at the Optical IO Card Level
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configure Timing at the Node Level
General Timing
BITS Facilities
Reference Lists
Configure Timing at the Optical IO Card Level
Related Information
Introduction
This document describes how you can provision timing on ONS 15454 through Cisco Transport Controller
(CTC). CTC provides two methods for you to provision timing and modify the settings:
(CTC). CTC provides two methods for you to provision timing and modify the settings:
At the node level, you can configure timing from the Provisioning/Timing tab. Here, you can
provision different timing modes and references for the entire node.
provision different timing modes and references for the entire node.
•
At each optical port, you can change the default Synchronous Status Message (SSM) settings.
•
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15454
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ONS 15454
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.