Cisco Cisco ONS 15600 Multiservice Switching Platform (MSSP) Guida Alla Risoluzione Dei Problemi
ONS 15600 Bridge and Roll in BLSR
Document ID: 64374
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Topology
Roll and Bridge
Related Information
Prerequisites
Requirements
Components Used
Conventions
Topology
Roll and Bridge
Related Information
Introduction
This document describes the steps required in order to perform the Bridge and Roll manually to move the
15600−15600 portion of a circuit within a bidirectional line−switched ring (BLSR) on ONS 15600.
15600−15600 portion of a circuit within a bidirectional line−switched ring (BLSR) on ONS 15600.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15454
•
Cisco ONS 15600
•
Cisco Transport Controller (CTC)
•
Components Used
The information in this document is based on these software and hardware versions:
CISCO ONS 15454 version 4: All
•
CISCO ONS 15600 version 1.1.0
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Topology
This document uses a lab setup with two ONS 15600s and eight ONS 15454s as Figure 1 shows.
Figure 1Topology