Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guida Alla Risoluzione Dei Problemi
Upgrading XC and XCVT Cards to XC10G Cards
Document ID: 21020
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Upgrade XC or XCVT Cards to XC10G Cards
Related Information
Prerequisites
Requirements
Components Used
Conventions
Upgrade XC or XCVT Cards to XC10G Cards
Related Information
Introduction
This document explains how to upgrade a Cross Connect (XC) or Cross Connect Virtual Tributary (XCVT)
card to a Cisco ONS 15454 XC10G card.
card to a Cisco ONS 15454 XC10G card.
Note: The example in this document explains how to upgrade dual XC and XCVT cards with dual XC10G
cards in the ONS 15454−SA−ANSI with live traffic.
cards in the ONS 15454−SA−ANSI with live traffic.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
A Path Unequipped alarm (UNEQ−P) alarm can occur when an XC card upgrade is in progress, if you
have E100 or E1000 cards in your system. The alarm appears and clears within a few seconds.
have E100 or E1000 cards in your system. The alarm appears and clears within a few seconds.
•
The procedure is not service−affecting. However, the upgrade causes a switch less than 50 ms in
duration. An XC or XCVT switch can cause a linear 1+1 optical carrier (OC−N) protection switch or
a bidirectional line switch ring (BLSR) protection switch. Cisco recommends a maintenance window.
However, a maintenance window is not absolutely necessary.
duration. An XC or XCVT switch can cause a linear 1+1 optical carrier (OC−N) protection switch or
a bidirectional line switch ring (BLSR) protection switch. Cisco recommends a maintenance window.
However, a maintenance window is not absolutely necessary.
•
This procedure assumes that the XC or XCVT cards are installed in the 15454−SA−ANSI shelf
(Release 3.1). You cannot perform this upgrade from shelves released earlier than 3.1, such as
15454−SA−NEBS3 or 15454−SA−NEBS3E shelves. The XC10G card requires the
15454−SA−ANSI.
(Release 3.1). You cannot perform this upgrade from shelves released earlier than 3.1, such as
15454−SA−NEBS3 or 15454−SA−NEBS3E shelves. The XC10G card requires the
15454−SA−ANSI.
•
You need to resolve any critical or major alarms before you begin this procedure. You can identify
these alarms from the Alarms tab in Network view.
these alarms from the Alarms tab in Network view.
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ONS 15454 running Cisco Transport Controller (CTC) Release 3.1 or later.
•
Two XC or XCVT cards that are installed in the ONS 15454−SA−ANSI.
•
Two XC10G cards that are available for installation.
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.