Cisco Cisco C880 M4 Storage Subsystem Libro bianco

 

 

© 2016 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. 

Page 14 of 140 

 

Cisco IMC Connection Settings 

Baud rate 

19200 

Data bit 

8 

Parity bit 

None 

Stop bit 

1 

Flow control 

None 

Emulation 

VT100 

Note:   The MMB initialization process takes about 6 minutes to complete. 

After the serial connection is opened, you will see an initial message and login prompt on the terminal software 

screen. Enter the login name as Administrator. This is the preset default administrator user account name. After 

entering this user name, you are asked to change your password immediately.  

3.  Enter a new password. Then reenter the same password. 

 

Cisco-1541432026 login: Administrator 

You are required to change the password immediately (root enforced) 

New password: 

Retype New password: 

Administrator > 

Note:   To see more commands and command syntax, enter the help command. 

Set the Integrated Management Controller IP Address 

Now set the IMC IP address. 

1.  Verify that the IMC ports are connected to the management network as shown in Figure 7.  

2.  After resetting the password as in the previous section, enter the commands shown here to set the IMC IP 

address and enable HTTP and Telnet access to it. 

 

Administrator> set  ip <ip address> <netmask> 

Administrator> set gateway <ip address> 

Administrator> set http enable 

Administrator> set telnet enable 

 

3.  The default HTTP port is 8081. You can change this port if required by entering the following command:  

 

Administrator> set  http_port 80