Cisco Cisco UCS C260 M2 Rack Server Scheda Tecnica

Storage controller 

Each Server Node module and optional I/O expander has a mezzanine connector. 
The C3X60 M3 server nodes (with v2 CPUs) support the Cisco UCS C3X60 12G SAS 
RAID Controller card in pass-through mode or with write cache and SuperCap 
backup, or the HBA pass-through controller (UCSC-C3X60-HBA). The C3X60 M4 
server nodes (with v4 CPUs) and the optional I/O expander support the Cisco UCS 
C3X60 RAID controller with 4GB cache. Note that the drive connections are 
multipath.

Access to the connector and card requires removing the server module or I/O 
expander and removing its top cover. 

The Cisco UCS C3X60 12G SAS RAID Controller card with RAID cache is available 
with an onboard Flash-Backed Write Cache (FBWC), as shown in the table below

The maximum number of drives that can be assigned to a single RAID group is 32.

All versions of the RAID controller support up to 60 drives. Each server node can 
be assigned specific drive combinations by means of CIMC Management.

The Cisco UCS C3X60 12G SAS HBA Controller is pass-through and both server 
nodes will see all the drives. Management of the drives will be at the OS Level 
with HBA Mode.

Note that the C3X60 M3 server node (only) supports the UCSC-C3X60-HBA.

1. All drives are hot swappable (no preconditioning of the component is required before removal while the system 

is powered on).

2. Drive carriers adapt the 2.5” SSD drives to the 3.5” drive bays in the top of the chassis.

UCSC-C3X60-R1GB

JBOD, RAID 0, 1, 5, 6, 10, 50, 60

1 GB

UCSC-C3X60-R4GB

JBOD, RAID 0, 1, 5, 6, 10, 50, 60

4 GB

UCS-C3K-M4RAID

JBOD, RAID 0, 1, 5, 6, 10, 50, 60

4 GB