Cisco Cisco Unified MeetingPlace 5.3 Manuale Di Manutenzione

meetingplace:tech$ hwconfig

Cabinet:                Motorola CPX8216T

Bus architecture:       CompactPCI

Processor card:         CPV5370 S/N=5129443

    Processor:          Pentium III, Model 8, 700 MHz

    Memory:             512 MB

    Temperature:        31C

    Voltages:           3.32V, 5.02V, 12.06V

Power Supplies:

    PS1:                OK, fan is OK

    PS2:                OK, fan is OK

    PS3:                OK, fan is OK

SCSI Adapter:           NCR 810

    DISK 1:             36000MB (SEAGATE  ST336704LW REV=0004)

    DISK 2:             36000MB (SEAGATE  ST336704LW REV=0004)

    Solid State Disk:   IMPERIAL "MG-35/400 ULTRA" S/N=0128 REV=B403

                        Battery: usage = 307 days, charge is OK

Ethernet:               Intel 8225x PCI 10/100 (0001af03c05e)

Modem:                  Absent or unrecognized

Smart Blades:

    Slot 16:            NMS CG6000C S/N=20363257 REV=5894-B2 MSC0 PRC0

Slot 15:            NMS CG6000C S/N=20363261 REV=5894-B2 MSC1 PRC1

If you do not see the two hard disk entries, do the following:

Power down the Cisco MeetingPlace system.

Reseat the hard disk.

Enter hwconfig.

If you still do not see the two hard disk entries, examine the hard disk connectors to see if they are 
damaged or dirty. If both sides of the connectors look good, try installing another hard disk.

If the second hard disk installs and works correctly, send the hard disk you tried to use as a replacement 
first back to the factory. If the second hard disk does not install or work correctly, contact Cisco TAC.

Ensure that all the gateways work. See the Administrator Guides for the specific gateways for 
information on determining that they are working correctly.

Ensure that you can call into the Cisco MeetingPlace system and attend a meeting. If you cannot call 
into the Cisco MeetingPlace system and attend a meeting, try reseating the hard disk. If that does not 
work, contact Cisco TAC.