Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Guida Alla Risoluzione Dei Problemi

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 ONS 15454 Chassis Swap
 Related Information

This document provides guidance to replace an in−service Cisco ONS 15454 chassis that runs release 9.1.
This document applies to all versions of Cisco ONS 15454 later than 3.2, provided you replace the linked
procedures for release 5 with the relevant Non−Trouble Procedure (NTP) and Detailed Level Procedure
(DLP) from the specific ONS 15454 Procedure Guide.

This procedure affects service. Use a maintenance window to perform this procedure. All traffic that drops at
the Network Element (NE) is affected for the duration of this procedure. Cisco highly recommends that you
temporarily re−route any traffic that drops at the NE on other facilities before you start the procedure.

Note: Review the entire procedure in this document, and print the necessary NTP or DLP before you start the
maintenance window.

Cisco recommends that you have knowledge of these topics:

Cisco ONS 15454

• 

The information in this document is based on these software and hardware versions:

Cisco ONS 15454 version 3.2 and later

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to Cisco Technical Tips Conventions for more information on document conventions.