Cisco Cisco VC220 Dome Network Camera Manuale Di Manutenzione

Network Setting > IP Filter

VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide

49

The Network Setting > IP Filter page controls the access permission of clients by 
checking the client’s IP addresses. When you complete the configuration, click 
Save to save the settings; otherwise click Cancel to discard the changes.

Check the Enable IP address filtering box to enable IP filtering. Uncheck the box 
to disable this feature.

There are two options for permission control in the drop-down list: Allow and 
Deny.

Only those clients whose IP address is in the Allowed List and not in the Denied 
List can connect to the Cisco VC220 network camera to receive the audio or video 
streaming. Both the Allowed List and Denied List can include a single IP address, a 
list of IP address ranges, or a network mask. 

If you want to add a new IP address, click the Add button and type the IP address 
you want to allow or deny. There are three methods of filtering in the drop-down 
list: Single, Range, and Network. 

If you want to add a new IP Address range, click the Add button and enter the 
Begin IP Address on the left text box and End IP Address in the right text box. If 
you want to add a new Network, click the Add button and enter the Network you 
want to Allow or Deny. 

If you want to remove an existing IP Address, IP address range, or Network, make 
a selection from the menu and click on the Delete button. Both the Allowed List 
and Denied List can have up to 10 entries.