Cisco Cisco D9824 Advanced Multi Decryption Receiver Guida All'Installazione
Configuring Transport Stream Information
241
Viewing the MPEG Output Transport Status
From the user interface of the D9824, choose Transport Stream > Output Transport
Status under MPEG over IP Output. The PID Output Status page is displayed.
Status under MPEG over IP Output. The PID Output Status page is displayed.
The Program Entry - Referenced PIDs table displays the specified PE ES PIDs
information on the output.
information on the output.
The Output Channel and PID Conflicts table displays a list of conflicts when the
DPM alarm is active.
DPM alarm is active.
Typical set up for Digital Program Mapping (DPM)
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop, or map.
2 From the user interface of the D9824, choose Transport Stream > ASI Output or
MPEG over IP Output.
3 From the Output Mode drop-down list, choose Full DPM Control.
4 If necessary, from the Descrambled drop-down list, choose whether the program
4 If necessary, from the Descrambled drop-down list, choose whether the program
is to be scrambled or descrambled for downstream viewing or monitoring.
5 Click Apply.