Cisco Cisco Packet Data Interworking Function (PDIF) Dépliant

 

▄  Cisco ASR 5x00 Statistics and Counters Reference 

 

 

Active SGW S11 Addr 

The IP address of S-GW connected to MME on S11 interface. 

SGW Control TEID 

Displays the TEID of the S-GW currently serving the UE. 

UE Offloading 

Displays the UE offload state for load rebalancing. Possible values are None, Marked, In-Progress and 
Done. 

UE Reachability Timer 

The configured value of the mobile reachability timer set for tracking UE in EMM session. 

Remaining Time 

The remaining time in seconds out of the configured value of the mobile reachability timer in the 
EMM session. 

Paging Proceed Flag 
(PPF) 

The current state of the Paging Proceed Flag indicating whether or not the UE is sending periodic 
TAUs within the span of the mobile reachability timer. If the UE fails to send a TAU within the timer 
value, this flag is set to “Paging Disabled” indicating that the MME is no longer paging the UE. 

ISR Status 

Displays if the session is using Idle mode Signaling Reduction (ISR). Possible configurations are 
Activated or Not activated. 

Peer SGSN 

Displays the IP address of the SGSN which has a context for this UE in support of Idle mode 
Signaling Reduction (ISR). A Peer SGSN address is only shown when ISR is activated for this 
session.  

UE Capability 
Information 

This group shows the UE Capability information for connected UE received by an MME service. 

Radio Capability 

The radio capability information received by an MME service for connected UE in UE capability 
exchange message. 

Supported Codec List 

The Supported Codec List information received by an MME service for connected UE in UE 
capability exchange message. 

Mobile Station 
Classmark 2 

The Mobile Station Classmark 2 information received by an MME service for connected UE in UE 
capability exchange message. 

Mobile Station 
Classmark 3 

The Mobile Station Classmark 3 information received by an MME service for connected UE in UE 
capability exchange message. 

Security Mode 
Information 

This group shows the status of NAS integrity check and NAS ciphering along with applicable 
algorithm as security mode information. It contains following information: 



 

NAS Integrity Check 



 

NAS Integrity Check Algorithm 



 

NAS Ciphering 



 

NAS Ciphering Algorithm 

Active ENodeB 
information 

This group shows the information of active eNodeB serving to this session. 

Global ENodeB ID 

The global identifier of active eNodeB serving to this session. 

S1AP End Point 

The IP address used by eNodeB on S1AP interface to connect with MME service. 

Crypto-map Name 

The name of the crypto map supporting this EnodeB association. 

MME UE S1AP ID 

Indicates the session identifier between MME and UE on S1AP interface serving to this session.