Cisco Cisco IOS Software Release 12.2(4)B
3
Release Notes for Cisco 6400 for Cisco IOS Release 12.2(4)B5
OL-2951-01
System Requirements
Note
When you are running multicast in an NRP-2 configuration, the NRP-2 should have 512 MB of memory.
Note
In most NRP-1 configurations, 64-MB DRAM is adequate for up to 750 sessions. If you have more
sessions, you need 128-MB DRAM. If you are using the NRP-1, for an upgrade from an earlier release
to Cisco IOS Release 12.2(4)B5, 128-MB DRAM is recommended.
sessions, you need 128-MB DRAM. If you are using the NRP-1, for an upgrade from an earlier release
to Cisco IOS Release 12.2(4)B5, 128-MB DRAM is recommended.
Supported Hardware
Cisco IOS Release 12.2(4)B5 supports the Cisco 6400 NRP-1, NRP-2, NRP-2SV, NSP, and NSP-S3B
modules. The NSP-S3B, otherwise identical to the NSP, is required if you want to use the Building Integrated
Timing Supply (BITS) Network Clocking software feature.
modules. The NSP-S3B, otherwise identical to the NSP, is required if you want to use the Building Integrated
Timing Supply (BITS) Network Clocking software feature.
Software Compatibility
For NRP-Service Selection Gateway (SSG) users, Cisco IOS Release 12.2(4)B5 works with the
Cisco Service Selection Dashboard (SSD) Releases 2.5(1) and 3.0(1), and Subscriber Edge Services
Manager (SESM) Release 3.1(1).
Cisco Service Selection Dashboard (SSD) Releases 2.5(1) and 3.0(1), and Subscriber Edge Services
Manager (SESM) Release 3.1(1).
Determining the Software Version
To determine the version of Cisco IOS software currently running on the Cisco 6400 NRP, log in to the
NRP and enter the show version EXEC command:
NRP and enter the show version EXEC command:
Router> show version
Cisco Internetwork Operating System Software
IOS (tm) C6400R Software (C6400R-G4P5-M), Version 12.2(4)B5
Cisco Internetwork Operating System Software
IOS (tm) C6400R Software (C6400R-G4P5-M), Version 12.2(4)B5
To determine the version of Cisco IOS software currently running on the Cisco 6400 NSP, log in to the
NSP and enter the show version EXEC command:
NSP and enter the show version EXEC command:
Router> show version
Cisco Internetwork Operating System Software
IOS (tm) C6400 Software (C6400S-WP-M), Version 12.2(4)B5
Cisco Internetwork Operating System Software
IOS (tm) C6400 Software (C6400S-WP-M), Version 12.2(4)B5
The output from these commands includes additional information, including processor revision
numbers, memory amounts, hardware IDs, and partition information.
numbers, memory amounts, hardware IDs, and partition information.
Upgrading to a New Software Release
For information about upgrading software on the Cisco 6400, including upgrading a single- or dual-NRP
system to a new software release, see the
system to a new software release, see the
located at