Cisco Cisco C880 M4 Server Guida All'Installazione
(3) Enter Maintenance Mode.
".
(4) Confirm that requirements for mounting the added options satisfy ones listed on table 3.2.2-2.
If requirements are not satisfied, check with the system administrator to satisfy the requirements.
Table 3.2.2-2
Section
Items to be confirmed
1
If mounting DIMMs and adding a new SB should be done,
confirm that requirements on 3.1.2 Conditions on mixing different types of
(5) Prepare the system board (SB) to which the DIMMs will be added.
".
(6) Mount the DIMMs.
".
(7) Install the system board (SB) in the main unit.
".
(8) Wait about 1 minute and confirm that the Alarm LED of the system board is off.
(9) Change Maintenance Mode disabled. See Appendix B.1.2,” Disabling maintenance mode
”.
SET0302030
3.2.3 Mounting the adding options (New SB)
Use the following steps to mount the added options.
ANNT)Confirm the quantities and installation locations with a system administrator.
(1) Confirm that requirements for mounting the added options satisfy ones listed on table 3.2.3. If
requirements are not satisfied, check with the system administrator to satisfy the requirements.
Table 3.2.3
Section
Items to be confirmed
1
If mounting DIMMs and adding a new SB should be done,
confirm that requirements on 3.1.2 Conditions on mixing different
(2) Prepare the new system board (SB) to which the DIMMs will be added.
".
(3) Confirm the numbers and mounting locations of the options.
(4) Mount the DIMMs.
".
28
CA92344-0577-01