Cisco Cisco Unified MeetingPlace 7.0 Guida All'Installazione

Cisco Unified MeetingPlace is extensively tested in its supported hardware and software environment. 
Diverging from the supported hardware and software environment by adding third-party components 
may negatively impact Cisco Unified MeetingPlace functionality and may impose limitations to your 
Cisco support.

Cisco qualifies a fixed set of required third-party software, including remote-access and antivirus. This 
set is documented in the System Requirements document for each release. Any third-party components 
that are not explicitly listed in the System Requirements documentation are not supported.

For a new Release 6.x system, Cisco Unified MeetingPlace Audio Server software is installed in 
manufacturing, so you do not need to install Audio Server software.

For upgrades, if you have the Cisco Unified MeetingPlace Audio Server hardware and are using Audio 
Server Release 5.3 or 5.4 software, you must upgrade the software to Audio Server Release 6.x yourself. 
(A Cisco Unified MeetingPlace Audio Server system running Release 5.2 cannot upgrade directly to 
Release 6.x. You must first upgrade to Release 5.4, then upgrade to Release 6.x.)

The Cisco Unified MeetingPlace Audio Server system requires a Cisco Unified MeetingPlace 8100 
series server.

For environmental requirements and hardware specifications for the Cisco Unified MeetingPlace 
8100 series server, see the “Preparing to Install the Cisco Unified MeetingPlace 8100 Series Server” 
chapter of the Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 
Release 6.x at 

http://www.cisco.com/en/US/products/sw/ps5664/ps5669/prod_installation_guides_list.html

.

The Cisco Unified MeetingPlace Audio Server must be connected to a network switch port that is 
configured for auto-negotiate. Cisco Unified MeetingPlace gateways must be connected to network 
switch ports that are configured for 100/1000 MB full duplex.

If the Cisco Unified MeetingPlace Audio Server is configured to use Cisco Unified Communications 
Manager in conjunction with a Cisco Unified MeetingPlace H.323/SIP IP Gateway, and if the 
Cisco Unified MeetingPlace H.323/SIP Gateway resides on a server with Cisco Unified 
MeetingPlace Web Conferencing, and if the network interface card (NIC) on the Cisco Unified 
MeetingPlace H.323/SIP IP Gateway is configured with more than one IP address, or there is more 
than one NIC, then you must do the following: In Cisco Unified Communications Manager, 
configure an H.323 Gateway to each NIC interface. Otherwise, outdials from the Cisco Unified 
MeetingPlace web interface may fail.