Cisco Cisco Content Switching Module Manuale Tecnico
Upgrade a Content Switching Module in Hybrid
Mode
Mode
Document ID: 45345
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Main Task
Task
Step−by−Step Instructions
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Main Task
Task
Step−by−Step Instructions
Verify
Troubleshoot
Related Information
Introduction
The Content Switch Module (CSM) is supported in both Hybrid and Native mode for the Catalyst switch.
When run with Hybrid OS on the Catalyst, the CSM cannot be upgraded using an external TFTP server. The
only way to upgrade the CSM is to use the MSFC's Bootflash.
When run with Hybrid OS on the Catalyst, the CSM cannot be upgraded using an external TFTP server. The
only way to upgrade the CSM is to use the MSFC's Bootflash.
This document provides information to upgrade a CSM in Hybrid mode.
Prerequisites
Requirements
Before attempting this configuration, ensure that you meet these requirements:
Refer to the CSM Release Notes. The upgrade procedure in the current release notes (as of March 1,
2004) are for Native IOS, not Hybrid.
2004) are for Native IOS, not Hybrid.
•
Components Used
The information in this document is based on these software and hardware versions:
Supervisor 1A with MSFC and Policy Feature Card (PFC)
•
Supervisor 2 with MSFC2
•
Supervisor 720
•
CSM version 2.7 or 3.1.2 or higher for Hybrid support
•
CatOS 7.5
•
Cisco IOS® 12.1(13)E3
•
TFTP server
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.