Cisco Cisco Unified MeetingPlace 8.6 Guida All'Installazione Rapida
Configuring Call Control for Cisco Unified MeetingPlace
How to Configure Call Control for Voice Conferencing
12
•
You perform this task in the Cisco Unified Communications Manager Administration pages.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Procedure
Step 1
Go to http://ccm-server/ccmadmin/main.asp, where ccm-server is the fully-qualified domain name or
IP address of the Cisco Unified Communications Manager server.
IP address of the Cisco Unified Communications Manager server.
Step 2
Log in with your Cisco Unified Communications Manager administrator username and password.
Step 3
Select Call Routing > Route/Hunt > Route Pattern.
Step 4
Select Add New.
Step 5
Configure the fields described in
.
Step 6
Configure all other required fields appropriately for your current deployment.
Tip
For field descriptions, select Help > This Page.
Step 7
Select Save.
Step 8
Select OK to any pop-up dialog box messages that you see.
Step 9
Repeat this procedure as necessary to route calls to each access phone number and DID number for your
Cisco Unified MeetingPlace system.
Cisco Unified MeetingPlace system.
Related Topics
•
module
•
module
Table 5
Fields for Adding a Route Pattern in Cisco Unified Communications Manager 4.x or 5.x
Field
Action
Route Pattern
Enter the Cisco Unified MeetingPlace phone number.
Requirements:
•
This number must not conflict with any other route pattern defined in this
Cisco Unified Communications Manager cluster.
Cisco Unified Communications Manager cluster.
•
Do not enter any spaces in this field.
Gateway/Route List
Select the
of one of the following, depending on your deployment:
•
Inter-cluster trunk to the Cisco Unified Communications Manager Release 6.1
(or a later release) server that provides front-end signaling for Cisco Unified
MeetingPlace.
(or a later release) server that provides front-end signaling for Cisco Unified
MeetingPlace.
•
(Cisco Unified Communications Manager 5.x only) SIP trunk to the
Cisco Unified Communications Manager Release 6.1 (or a later release) server
that provides front-end signaling for Cisco Unified MeetingPlace.
Cisco Unified Communications Manager Release 6.1 (or a later release) server
that provides front-end signaling for Cisco Unified MeetingPlace.
Call Classification
Select OffNet.