Cisco Headend System Release 2.7 Guida All'Installazione
Set Up the BFS Host
4023737 Rev C
135
3 Select the Hosts tab; then double-click on the existing DNCS host. The Set Up
BFS Host window opens.
4 Follow these directions to configure the Set Up BFS Host window.
a In the BFS In-Band Mode field, select ASI.
b In the Inband Device Name field, type /dev/Hmux0.
c In the Host Name field, type the name of the DNCS host.
b In the Inband Device Name field, type /dev/Hmux0.
c In the Host Name field, type the name of the DNCS host.
Example: dncsatm
d In the QAM BFS Input TSID field, type the value that represents the output
TSID for the ASI_BFS MPEG source.
e In the RF Output TSID for BFS Port field, type the value that represents the
output TSID for the BFS QAM or the BFS port on an MQAM.
f In the PSI Interval field, type 80.
g In the Port field, select 0.
h In the Bandwidth field, type 38.80.
i Are you configuring Direct ASI on a DNCS (rather than an RNCS)?
g In the Port field, select 0.
h In the Bandwidth field, type 38.80.
i Are you configuring Direct ASI on a DNCS (rather than an RNCS)?
–
If yes, click DNCS Host.
–
If no, go to step 5.