Cisco Cisco Process Orchestrator 3.0 Guida All'Installazione
4-4
Cisco Process Orchestrator Installation Guide
OL-24931-02
Chapter 4 Configuring a High Availability Environment
Balancing Client Connection Loads
Step 3
Configure the northbound ports:
a.
Choose File > Environment Properties > Web Service and enable the Web Services. By default,
the port for HTTPS is 61526 and for HTTP is 61527.
the port for HTTPS is 61526 and for HTTP is 61527.
Figure 4-4
Web Service Tab
b.
Set up SSL on your Process Orchestrator servers.
You should not need to do any additional certificate setup or configuration on the load balancer
itself.
itself.
c.
Configure any Northbound connections to connect through the load balancer. For example, to
connect to the Target Northbound Web Service using the default HTTPS port, connect to:
connect to the Target Northbound Web Service using the default HTTPS port, connect to:
https://<sjc-ms-testlb.tidalsoft.local>:61526/WS/Target?wsdl
Step 4
Configure the Web Console:
a.
Configure the environment to use one of the following:
–
The load balancer URL. This is what gets set as the task URL for tasks and can be sent in emails
as a URL location to the Web Console. This is also what is used to open and complete the task
using the Web Console.
as a URL location to the Web Console. This is also what is used to open and complete the task
using the Web Console.
-or-
–
The IP address of the cluster in the Web Console location.