Cisco Cisco Aironet 1200 Access Point
19
Release Notes for Cisco Aironet 350, 1100, 1130AG, 1200, and 1230AG Series Access Points for Cisco IOS Release 12.3(2)JA
OL-6252-01
Important Notes
Pings and Link Tests Sometimes Fail to Clients with both Wired and Wireless
Network Connections
Network Connections
When you ping or run a link test from an access point to a client device installed in a PC running
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Layer 3 Mobility Not Supported on Repeaters and Workgroup Bridges
Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
WLSM Required for Layer 3 Mobility
You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not
support Layer 3 mobility, client devices cannot associate using that SSID.
Change to Default IP Address Behavior
Cisco IOS Release 12.3(2)JA changes the default behavior of access points requesting an IP address
from a DHCP server:
from a DHCP server:
•
When you connect a 350, 1130AG, or 1200 series access point with a default configuration to your
LAN, the access point requests an IP address from your DHCP server and, if it does not receive an
address, continues to send requests indefinitely.
LAN, the access point requests an IP address from your DHCP server and, if it does not receive an
address, continues to send requests indefinitely.
•
When you connect an 1100 series access point with a default configuration to your LAN, the 1100
series access point makes several attempts to get an IP address from the DHCP server. If it does not
receive an address, it assigns itself the IP address 10.0.0.1 for five minutes. During this five-minute
window, you can browse to the default IP address and configure a static address. If after five minutes
the access point is not reconfigured, it discards the 10.0.0.1 address and reverts to requesting an
address from the DHCP server. If it does not receive an address, it sends requests indefinitely. If you
miss the five-minute window for browsing to the access point at 10.0.0.1, you can power-cycle the
access point to repeat the process.
series access point makes several attempts to get an IP address from the DHCP server. If it does not
receive an address, it assigns itself the IP address 10.0.0.1 for five minutes. During this five-minute
window, you can browse to the default IP address and configure a static address. If after five minutes
the access point is not reconfigured, it discards the 10.0.0.1 address and reverts to requesting an
address from the DHCP server. If it does not receive an address, it sends requests indefinitely. If you
miss the five-minute window for browsing to the access point at 10.0.0.1, you can power-cycle the
access point to repeat the process.