Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
GGSN Service Configuration Procedures
▀ FA Services Configuration
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
OL-22944-01
<
> is the maximum amount of time that the FA service waits for a Registration Rely message
from the HA. It is measured in seconds and can be configured to any integer value from 1 to 65535. The
default value is 45.
default value is 45.
For more information on authentication mn-aaa commands/keywords that configure additional parameters and
options, refer FA Service Configuration Mode Commands chapter of Command Line Interface Reference.
Revocation Message Configuration
Use the following example to configure the FA service for controlling the negotiation and sending of the I-bit in
revocation messages:
revocation messages:
Notes:
By default the system will not send the I-bit in the revocation message.
FA Service Configuration Verification
Step 1
Verify that your FA service is configured properly by entering the following command in Exec Mode:
The output from this command should look similar to the sample shown below. In this example an FA service named
fa1 was configured in the isp1 context.
fa1 was configured in the isp1 context.