Cisco Cisco Web Security Appliance S390 Guida Utente

In this example, the 

snmpconfig

 command is used to enable SNMP on the “PublicNet” interface on port 

161. A passphrase for version 3 is entered and then re-entered for confirmation. The system is configured 
to service version 1 and 2 requests, and the community string 

public

 is entered for GET requests from 

those versions 1 and 2. The trap target of 

10.1.1.29

 is entered. Finally, system location and contact 

information is entered.

example.com> snmpconfig

Current SNMP settings:

SNMP Disabled.

Choose the operation you want to perform:

- SETUP - Configure SNMP.

[]> setup

Do you want to enable SNMP? [N]> y

Please choose an IP interface for SNMP requests.

1. Management (192.168.1.1/24: wsa01-vmw1-tpub.qa)

[1]>

Enter the SNMPv3 passphrase.

>

Please enter the SNMPv3 passphrase again to confirm.

>

Which port shall the SNMP daemon listen on?

[161]>

Service SNMP V1/V2c requests? [N]> y

Enter the SNMP V1/V2c community string.