Cisco Cisco UCS B230 M1 Blade Server Scheda Tecnica

Cisco UCS B260 M4 Blade Server (with Intel® Xeon E7 v2 CPU)

SUPPLEMENTAL MATERIAL

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B260M4.html

CPU Removal and Installation (“pick n place”) Tool Set

The Pick n Place tool set is used to install a CPU in its socket without damage. It must be used each time a
CPU is installed in the server.

Instructions for using this tool set are found at the following link:

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B260M4.html

Thermal Grease (with syringe applicator) for CPU to Heatsink Seal

Thermal grease must be applied to the top of the CPU where it comes in contact with the heat sink.
Instructions for applying thermal grease are found at:

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B260M4.html

NOTE: When you purchase a spare CPU, the Pick n Place Toolkit is included.

CAUTION:

DO NOT use thermal grease available for purchase at any commercial
electronics store. If these instructions are not followed, the CPU may
overheat and be destroyed.

NOTE: When you purchase a spare CPU, the thermal grease with syringe applicator
is included.