Cisco Cisco Virtualization Experience Client 2111 Guida Dell'Amministratore
5-4
Cisco Virtualization Experience Client 2112/2212 ICA Administration Guide for WTOS 7.0_214
OL-215152-01
Chapter 5 Performing Diagnostics
Network Tools
•
Stop—Terminates the ping request and leaves the Ping dialog box open (so you can read the
summary posted in the data area).
summary posted in the data area).
Using Trace Route
The Trace Route dialog box executes the tracert diagnostic utility and displays response messages. The
tracert utility traces the path from your zero client to a network host. The host parameter is either a valid
host name or an IP address. The tracert utility sends out a packet of information three times to each
device (routers and computers) in the path and displays the round trip response times and identifying
information in the message box.
tracert utility traces the path from your zero client to a network host. The host parameter is either a valid
host name or an IP address. The tracert utility sends out a packet of information three times to each
device (routers and computers) in the path and displays the round trip response times and identifying
information in the message box.
Figure 5-5
Trace Route
Use the following guidelines:
•
Enter Hostname or IP—Enter the IP address, DNS-registered host name, or WINS-registered host
name of the target to be traced.
name of the target to be traced.
•
Data area—Displays round-trip response time and identifying information for each device in the
path.
path.
•
Start—Executes the tracert command.
•
Stop—Terminates the tracert command and leaves the Trace Route dialog box open (so you can read
the information posted in the data area).
the information posted in the data area).