DAXTEN 1014-108P Manuale Utente

 

The SCOUT Switch can be reset without disconnecting or powering down your computers either by 
pressing down Button 1 on the front panel for 2 seconds, or with the hotkey sequence 

 

 

 

To send Hot Key commands to the SCOUT switch, press and release the 

Scroll Lock Scroll Lock 

within 2 seconds. Press a command key for the desired effect. The following commands are 
supported: 
 

2 digit bank number + 
2 digit port number 

Switches to the desired PC  

Switch to previous PC 

Switch to next PC 

Next lower unit (bank) 

Next higher unit (bank) 

Sound ON/OFF for Auto-Scan 

Auto-Scan ON 

 

 

any key 

Stop Auto Scan 

Refresh EEPROM 

Find PC by Name 

Displays OSD 

Reset KVM 

 
In Auto-Scan mode, the image shown on the monitor will automatically switch to the next computer. 
After the last computer has been shown, the first computer will be shown again. 

 Each keystroke should be followed by its next keystroke within 2 seconds! 

 After you have set up cascaded SCOUT Switches, and you want to initialize this 

setup for the first time, you should perform the reset on the first (master) switch (that is, 
the first bank) to initialize.  Also remember to turn on all the other switches on the daisy-
chain. The reason is that the first (master) switch will send message to the slave units.  If 
the slave units are not there to receive and respond to this reset message, system errors 
will occur. If you want a reset later during your operation, you can do on the SCOUT’s 
other than the master unit. 

 In Auto Scan mode there is no mouse or keyboard control. Press any key to exit 

the Auto-Scan mode. The SCOUT switch will stop at the last PC shown 

 

 

Pressing the individual PC buttons on the front of the SCOUT will switch the signal to the desired 
computer.