Cisco Cisco TelePresence MX700 Riferimenti tecnici

D15335.03

 Cisco TelePresence MX700 and MX800 API Reference Guide CE8.1, APRIL 2016. 

Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

30

Cisco TelePresence MX700 and MX800

API Reference Guide

Terminal connections

Managing feedback subscriptions

To register, list and deregister feedback expressions you 

use the command xFeedback and its corresponding sub 

commands.

The registered expressions are only valid for the currently 

active connection. If you open two Telnet sessions and 

register to get feedback in one session, you do not receive 

feedback in the other session. This also means that if you 

disconnect from a session, you have to re-register all expres-

sions after reconnecting. 

You can register up to 38 expressions. 

Feedback output

The feedback output is exactly the same as you get 

when querying the system using the xConfiguration 

and xStatus commands. E.g., if you issue the command 

xStatus Standby Active

 on the command line the result is:

*s Standby Active: On

** end

If you have registered for feedback on status changes the 

feedback you get when the system goes to standby-mode 

will be exactly the same: 

*s Standby Active: On

** end

This means that when you are programming against the 

device you only need to handle one format. 

Example: Managing feedback subscriptions

A: Register feedback expressions.

Write in: 

xFeedback register /Status/Audio

Result: 

** end

 OK

Write in:  

xFeedback register /Event/CallDisconnect

Result: 

** end

 OK

Write in:  

xFeedback register /Configuration/Video/ 

 MainVideoSource

Result: 

** end

 OK

B: List out currently registered expressions.
Write in:  

xFeedback list

Result: 

/Configuration/Video/MainVideoSource

 /Event/CallDisconnect

 /Status/Audio

 

** end

 OK

C: Deregister feedback expressions.
Write in:  

xFeedback deregister /Event/

CallDisconnect

Result: 

** end

 OK

Write in:  

xFeedback deregister /Status/Audio

Result: 

** end

 OK

D: List the new feedback expressions.
Write in:  

xFeedback list

Result: 

/Configuration/Video/MainVideoSource

 

** end

 OK

Introduction

About the API

xConfiguration

Appendices

xCommand

xStatus



About the API