Cisco Cisco TelePresence MX700 Guida All'Installazione

Setting the date, time and location

(When not set by a provisioning system)

When setting up your video conference system, you should 

check that the date and time settings are correct. Among other 

things this information is used to time stamp messages transmit-

ted to gatekeepers and other network elements.

If you operate your system using the Touch controller, the time 

is shown in the top right corner of the Touch controller display; 

if you operate your system using a remote control, the time 

and date is shown in the top right corner of the main display.

1.  Go to the 

tab and select

.

Open the 

settings from the left column.

2.  Select your preferred date format in the 

 drop 

down list.

3.  Select your preferred time format in the 

 drop 

down list.

4.  Select your time zone in the 

 drop down list. 

5.  Open the 

settings from the left column.

* NTP mode: 

Auto: The time is regularly updated using an NTP server. The NTP server 

address is automatically obtained from the network (DHCP). 

Manual: The time is regularly updated using an NTP server. You must 

manually enter the NTP server address. 

Off: You must set the time manually. The time is not updated automatically.

If you are changing a value setting, 

you have to always click 

to confirm the change.

Back to task overview

Cisco TelePresence Video Systems

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014. 

Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 

27

Getting Started Guide

Contents

Introduction

User interfaces

Configuration

Appendices

Contacts

Configuration