Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.

161

Cisco TelePresence MX700 and MX800

Administrator Guide

High: Requires nearly optimal video conferencing lighting conditions and a good quality

video input in order to achieve a good overall experience. Rather high resolutions will be

used.

Video Input Connector [1..5] OptimalDefinition Threshold60fps

For each video input, this setting tells the system the lowest resolution where it should

transmit 60fps. So for all resolutions lower than this, the maximum transmitted frame rate

would be 30fps, while above this resolution 60fps would also be possible, if the available

bandwidth is adequate.

Requires user role: ADMIN
Default value: 1280_720

Value space: 512_288/768_448/1024_576/1280_720/1920_1080/Never

512_288: Set the threshold to 512x288.
768_448: Set the threshold to 768x448.
1024_576: Set the threshold to 1024x576.
1280_720: Set the threshold to 1280x720.
1920_1080: Set the threshold to 1920x1080.
Never: Do not set a threshold for transmitting 60fps.

Video Input Connector [1..4] PresentationSelection

Define how the video system will behave when you connect a presentation source to the

video input. In general, any input source can be used as a presentation source; normally,

the main camera will not be used as a presentation source.
If the video system is in standby mode, it will wake up when you connect a presentation

source. Sharing the presentation with the far end requires additional action (select Share on

the user interface) except when this setting is set to AutoShare.

Requires user role: ADMIN
Default value: Connector 1, 2: Manual Connector 3, 4: OnConnect

Value space: Connector 1: Manual Connector 2: AutoShare/Desktop/Manual/OnConnect

for single camera systems, and Manual for dual camera systems Connector 3, 4:

AutoShare/Desktop/Manual/OnConnect

AutoShare: While in a call, the content on the video input will automatically be presented

to the far end as well as on the local screen when you connect the cable, or when the

source is activated otherwise (for example when a connected computer wakes up from

sleep mode). You do not have to select Share on the user interface. If a presentation

source is already connected when you make or answer a call, you have to manually

select Share on the user interface.
Desktop: The content on the video input will be presented on the screen when you

connect the cable, or when the source is activated otherwise (for example when a

connected computer wakes up from sleep mode). This applies both when idle and in a

call. Also, the content on the video input will stay on the screen when you leave the call,

provided that it was the active input at the time of leaving.
Manual: The content on the video input will not be presented on the screen until you

select Share from the user interface.
OnConnect: The content on the video input will be presented on screen when you

connect the cable, or when the source is activated otherwise (for example when a

connected computer wakes up from sleep mode). Otherwise, the behavior is the same

as in manual mode.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



System settings