Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15331.04 MX700 and MX800 Administrator Guide CE8.2, OCTOBER 2016.

Cisco TelePresence MX700 and MX800

Administrator Guide

MX700 and MX800 Dual support one external monitor, and

MX800 Single supports two external monitors, in addition to the

video systems’ integrated monitor(s).

The video system distributes the layout on all available monitors.

Always switch off power when you connect and

disconnect monitors and other peripherals.

Remove the video system’s left side cover to get access to the

codec connector panel and power switch. The cover is fastened

with magnets.

Do not disconnect the integrated monitors from the

codec, and do not use those connectors for anything else.

The reason for this is that the integrated monitor

connections make use of multichannel audio, which

drives the included speaker systems. Inserting third party

equipment is likely to break the audio chain, causing the

video system to fail from an audio perspective.

These connectors are used

for the integrated monitors.

Do not disconnect!

Connector 3 (DVI-I)

External monitor

Codec connector panel

Audio Line outputs

(Euroblock, 3.5 mm)

Connector 3 (DVI-I)

This connector is used for

the integrated monitor.

Do not disconnect!

External monitor

Codec connector panel

External monitor

Connector 2 (HDMI)

Audio Line outputs

(Euroblock, 3.5 mm)

MX700 and MX800 Dual

MX800 Single

Connect external monitors

(page 1 of 3)

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



Peripherals